T5 Texture mat style 5

Between 8cm - 9cm - Please read recommended instructions to get the best results - Roll slab firmly onto your surface.

Gently dust your clay slab with cornflour/starch. Place the texture mat face down. Applying even pressure to the mat pushing the mat into the clay. To achieve best imprint results you will need to apply firm pressure. I recommend the palm of your hand and standing to apply even pressure. Make sure you apply pressure to the entire mat. Using these mats may take a few attempts to perfect the imprint. Once you get it right you will be blown away with the imprint details.

Please note these cutters are highly detailed. I recommend using cornflour and the double push method. See my hight lights on my instagram page to watch a video on how to use more detailed cutters.

Made with PLA biodegradable plastic. Cutter colours will vary.

Suitable for 2-4mm thick polymer clay slabs.

• For more detailed cutters I recommend using corn flour directly onto your cutters or brush lightly on your clay slab, this avoids the clay from sticking to the cutters. Use a pin to pick out any clay that is stuck.

• A great tip is to make sure your clay is firmly rolled out onto your work surface before cutting. This helps the clay to stick when you remove the cutter.

• Or water on your cutter also works well. Ceramic tiles are great to use, cut your slab directly on the tile, then pop straight into your oven.

• Clean with baby wipes or cold water with dish liquid. I recommend to always clean cutters each time you use new colours to avoid colour transfer. Clean immediately after cutting acrylic paint with silkscreens.
  
  
• Do not put in the dishwasher. Keep away for heat, do not bake cutters in the oven.